Teks & tutorials 5 min read
Grain to grain transfer tek: how to expand one colonised bag into five
One colonised bag is a start. One colonised bag poured into five fresh ones is a season. The grain to grain transfer is the quickest way to multiply spawn, and the quickest way to multiply a mistake.
A grain to grain transfer, the g2g, takes a bag of fully colonised grain and uses it to inoculate fresh sterilised bags. A handful of colonised kernels goes into each new bag, you shake, and a week later you have a bag that looks exactly like the one you started with. It is how one syringe or one plate turns into enough spawn for a whole season of tubs. We bag sterilised grain in 1kg and 2kg sizes across wheat, oats, corn and milo, and the transfer below works the same way for all four. Because every batch is hand-made in small runs, the fresh bags you pour into are as new as the spawn you pour from.
The ratio: 10 to 20 percent
Use 10 to 20 percent colonised grain by weight. For a 1kg fresh bag that is 100 to 200 g of spawn, about a cupped handful; for a 2kg bag, 200 to 400 g. So one 1kg colonised bag expands into five to ten fresh 1kg bags. Less than 10 percent works but slows the run and gives contaminants more time; more than 20 percent is spawn that could have been another bag. If you bought colonised grain spawn from us rather than growing your own, the same ratio applies, and the shortcut post covers what to do with the rest of it.
The clean grain to grain transfer, step by step
Both bags are open at the same time, so this is a still air box job, not a kitchen bench job. Fans off, windows shut, bench and gloves wiped with 70% alcohol. Before you open anything, break up the colonised bag through the plastic until there are no lumps, and wipe the outside of every bag, especially the top seals you are about to cut.
- Open the colonised bag
Cut across the top seal above the filter patch. Keep the opening pinched shut between pours.
- Open a fresh bag and pour
Cut the fresh bag's top seal, hold it open, and pour 10 to 20 percent of the colonised grain straight in. Keep both openings low in the box, away from your face, and never reach over them.
- Reseal the fresh bag
Fold the top over twice and tape it, or impulse-seal it, with the filter patch above the grain. A bag with a wide top is easiest to pour into and easiest to seal.
- Repeat, then shake
Reseal the colonised bag between pours. Once each fresh bag is done, shake it until the white kernels are spread evenly through the uncolonised grain. Label with species, date and generation number.
Resealing: tape, impulse sealer, or a wide top
An impulse sealer gives the cleanest seal in a second. Without one, fold the cut edge over twice and tape along the fold, then across the ends. The seal does not need to be airtight, because the filter patch does the breathing; it needs to keep spores and insects out. What matters more is that the filter patch finishes above the grain line. A patch buried in grain is a patch that cannot work, and the bag stalls.
Incubation is fast: about a week
This is the payoff. A bag inoculated with liquid culture starts from two or three wet spots and takes three to four weeks. A g2g bag starts from hundreds of colonised kernels spread through the whole bag, so there is nothing to wait for. At 20 to 26°C in the dark, expect visible growth around every kernel within two days and a bag that is white through in seven to ten days. No break and shake is needed, because you shook at the start. Milo and oats can be done in under a week; corn takes a few days longer.
How many generations before you go back to agar
Two or three. Each transfer carries forward whatever was in the bag before it, and mycelium that has been on grain for generations can lose vigour, grow slower and fruit less. The usual rhythm is: agar or liquid culture into grain, that bag expands into five, those five go to substrate or expand once more, and then you start the line again from a plate. Keep a plate in the fridge as the library and the grain as the print run. Our grain spawn explained post has more on what spawn is actually doing in the bag.
The risk: one contaminant multiplies
The other risk is the open bag itself. Two open bags in a still air box is manageable; two open bags on a bench under a ceiling fan is a lottery. Keep the openings small and the time short.
Why milo and oats expand best
A g2g depends on the colonised grain breaking up into separate kernels, because each kernel is one inoculation point in the fresh bag. Milo is tiny and hard-shelled, so it breaks apart instantly and gives the most points per handful of any grain we bag. Oats keep their husk and stay loose, so they pour cleanly without lumps. Wheat is close behind. Corn is the one to be patient with: the big kernels clump and need a proper knead before you open the bag, and a handful of corn carries fewer points than a handful of milo.
The economics for a season
Count it in bags. One 1kg colonised bag, from a syringe or a plate, expands into five 1kg bags in a week. At a 1:2 spawn to substrate ratio, those five bags run 10 kg of substrate: two large tubs or a row of small ones. Expand once more and you have twenty-five bags, more than most home growers can fruit in a season. The culture is the one-off; everything after it is fresh grain, which is why we sell it in 1kg and 2kg bags rather than making you buy spawn every time.
Questions people ask
What ratio do I use for a grain to grain transfer?
10 to 20 percent colonised grain by weight into fresh sterilised grain. For a 1kg bag that is roughly a cupped handful of spawn.
How long does a g2g bag take to colonise?
About a week at 20 to 26°C. Seven to ten days is typical; milo and oats are the fastest, corn a few days slower.
How many times can I expand grain spawn?
Two or three generations, then start again from agar or a fresh liquid culture. Every transfer carries contamination risk, and the mycelium slowly loses vigour.
Do I need to shake a g2g bag?
Yes, once, right after you pour and seal it. That spreads the colonised kernels through the fresh grain. There is no break and shake later, because the bag colonises evenly from the start.
Written by the Aus Myco Kingdom crew. Everything here is general growing information for gourmet and medicinal species; your room, your climate and your culture will have the final say.
Related guides
All guidesGrain & spawn 3 min read
Colonised grain spawn: the fastest way to a first flush, and how to make one bag into five
Colonised spawn is the part of the grow that is already done. Use it straight away, or make it last a season.
Teks & tutorials 5 min read
Agar to grain transfer tek: moving a clean wedge into a sterilised grain bag
Liquid culture is faster to start. Agar is cleaner. When you have a plate with one vigorous, uncontaminated sector on it, this is how you turn it into a bag of spawn.
Teks & tutorials 5 min read
Mushroom tub tek for Australia: spawn to bulk substrate in a tub, step by step
Grain spawn plus a bag of substrate in a tub with a lid is the bulk method, and it is how most Australian home growers get their first serious harvest of oysters. Here is the whole run.
